((((((HUGS TO ALL))))))
Jon's alternating pressure, low air loss mattress, which we purchased for him a couple of years ago, is deflating on one side and bottoming out under his bum. This is the same problem we had with the last mattress (same exact pump/mattress system), which caused us to replace it.
For Jim to thoroughly check the mattress system, Jon must be out of bed. The tubing is all on the bottom and underneath a series of cells.
Now that Jon is more stable, we want to get him out of bed, so we planned to do that today.
First problem: Jon expressed great pain with turning last night and today.
Second problem: Blood suddenly appeared in Jon's urine. Not severe and not long lasting. Perhaps the catheter became disturbed. And Jon is still dealing with a low hemoglobin and rebuilding red blood cells.
Third problem: Jon's lift doesn't work! It's been unplugged and turned off for so long that it needs recharging (at least we hope that is all that it needs).
The third problem caused us to delay getting Jon out of bed, obviously.
The dilemma is this:
A likely cause for Jon's pain is the dysfunctional mattress. We have to fix that, so that he will be more comfortable. But to fix it, we have to lift him out of bed and into another room to his chair. We worry that the transfer will be too painful for him. We also worry about his catheter being disturbed again and causing more blood loss during the transfer.
But we must fix the mattress, or at least figure out whether it is reparable. His last one was not; hence we bought this one. If this one is irreparable, then we have to buy him a new system, but we were so sold on this system, when we first saw it several years ago, because it has a perimeter to prevent falling or getting feet caught in the bed rails.
In 10 years, Jon has had 4 alternating pressure low air loss mattresses. The pumps fail. The mattresses leak and bottom out. These systems cost $2-3,000. After Jon's second system, Medi-Cal refused to pay for an alternating pressure low air loss mattress for Jon. A static mattress, costing about $600, was sent instead. So, we've bought his last 2 mattresses, and we'll have to buy a replacement, if we can't identify the problem, when we're able to get Jon out of bed to look.
These systems do not come with manuals, and there are no service personnel in our area to trouble shoot the problem. We have to call an 800 number and have a rep "walk (us) through" step by step looking for the problem.
Durable Medical Equipment is where the money is, friends. You just sit in your home and take orders that go to a warehouse for shipment, unless you want to look legit and have a tiny office in an industrial park, where you receive the warehouse orders and deliver locally. No quality control. No regulations. Charge whatever price you want to charge, as long as it is somewhat competitive, and make a huge profit.
I find that infuriating.
Shouldn't a medical air mattress last longer than 2 years? Shouldn't a mattress, costing $2k, last longer than 2 years?
Fortunes are made literally off of the backs of people, who are ill and/or disabled. And our son is one of those millions of people.
And, because these products are poorly constructed or assembled, or they use cheap materials, they fail. When they fail, the person, who desperately needs this mattress, suffers. Jon is suffering, without a doubt.
And we, as his caregivers, are suffering. While worrying about our son and providing his care, we have to become service technicians now, on top of all of our other adopted careers. And then we have to become experts in mattress systems to determine whether there is a better system out there to replace this one.
Our first goal every moment of every day is Jon's comfort and maintaining his health. We can't do that if we have a sagging mattress.
It's the total disregard for the person, who needs the DME, in favor of the profit, that really frosts my cookies.
And I could write great letters to assorted elected officials and medical boards, and waste my time. No one, who might have the power to change things, gives a fig. I know this for a fact, based on the reams of letters I've written in the past 35 years or so.
For Jon, we will prevail somehow. We will get him out of bed, as long as the lift works, tomorrow, and we will scour that mattress for any evident cause for the deflation. If needed, we'll order a new mattress, then send these two back to the manufacturer and ask for their repair or a refund. (Ha Ha Ha! Like that will happen ...) If the lift needs to be serviced, we will contact our friend with the lift company, who will be more than happy to assist us, as always. He might even be able to recommend a mattress system.
A Lesson I Have Learned From Life: It's never just one thing.
This dilemma must be resolved. So it will be. At least partially.
Love & Light,
Rose
Jon's alternating pressure, low air loss mattress, which we purchased for him a couple of years ago, is deflating on one side and bottoming out under his bum. This is the same problem we had with the last mattress (same exact pump/mattress system), which caused us to replace it.
For Jim to thoroughly check the mattress system, Jon must be out of bed. The tubing is all on the bottom and underneath a series of cells.
Now that Jon is more stable, we want to get him out of bed, so we planned to do that today.
First problem: Jon expressed great pain with turning last night and today.
Second problem: Blood suddenly appeared in Jon's urine. Not severe and not long lasting. Perhaps the catheter became disturbed. And Jon is still dealing with a low hemoglobin and rebuilding red blood cells.
Third problem: Jon's lift doesn't work! It's been unplugged and turned off for so long that it needs recharging (at least we hope that is all that it needs).
The third problem caused us to delay getting Jon out of bed, obviously.
The dilemma is this:
A likely cause for Jon's pain is the dysfunctional mattress. We have to fix that, so that he will be more comfortable. But to fix it, we have to lift him out of bed and into another room to his chair. We worry that the transfer will be too painful for him. We also worry about his catheter being disturbed again and causing more blood loss during the transfer.
But we must fix the mattress, or at least figure out whether it is reparable. His last one was not; hence we bought this one. If this one is irreparable, then we have to buy him a new system, but we were so sold on this system, when we first saw it several years ago, because it has a perimeter to prevent falling or getting feet caught in the bed rails.
In 10 years, Jon has had 4 alternating pressure low air loss mattresses. The pumps fail. The mattresses leak and bottom out. These systems cost $2-3,000. After Jon's second system, Medi-Cal refused to pay for an alternating pressure low air loss mattress for Jon. A static mattress, costing about $600, was sent instead. So, we've bought his last 2 mattresses, and we'll have to buy a replacement, if we can't identify the problem, when we're able to get Jon out of bed to look.
These systems do not come with manuals, and there are no service personnel in our area to trouble shoot the problem. We have to call an 800 number and have a rep "walk (us) through" step by step looking for the problem.
Durable Medical Equipment is where the money is, friends. You just sit in your home and take orders that go to a warehouse for shipment, unless you want to look legit and have a tiny office in an industrial park, where you receive the warehouse orders and deliver locally. No quality control. No regulations. Charge whatever price you want to charge, as long as it is somewhat competitive, and make a huge profit.
I find that infuriating.
Shouldn't a medical air mattress last longer than 2 years? Shouldn't a mattress, costing $2k, last longer than 2 years?
Fortunes are made literally off of the backs of people, who are ill and/or disabled. And our son is one of those millions of people.
And, because these products are poorly constructed or assembled, or they use cheap materials, they fail. When they fail, the person, who desperately needs this mattress, suffers. Jon is suffering, without a doubt.
And we, as his caregivers, are suffering. While worrying about our son and providing his care, we have to become service technicians now, on top of all of our other adopted careers. And then we have to become experts in mattress systems to determine whether there is a better system out there to replace this one.
Our first goal every moment of every day is Jon's comfort and maintaining his health. We can't do that if we have a sagging mattress.
It's the total disregard for the person, who needs the DME, in favor of the profit, that really frosts my cookies.
And I could write great letters to assorted elected officials and medical boards, and waste my time. No one, who might have the power to change things, gives a fig. I know this for a fact, based on the reams of letters I've written in the past 35 years or so.
For Jon, we will prevail somehow. We will get him out of bed, as long as the lift works, tomorrow, and we will scour that mattress for any evident cause for the deflation. If needed, we'll order a new mattress, then send these two back to the manufacturer and ask for their repair or a refund. (Ha Ha Ha! Like that will happen ...) If the lift needs to be serviced, we will contact our friend with the lift company, who will be more than happy to assist us, as always. He might even be able to recommend a mattress system.
A Lesson I Have Learned From Life: It's never just one thing.
This dilemma must be resolved. So it will be. At least partially.
Love & Light,
Rose


Comment